Dialogic SS7G2X - Manual (Page 68)

68
Chapter 6 Command Definitions
6.6.2 C7LSC – CCS SS7 Link Set Change
Synopsis
This command allows changes to the configuration of an SS7 link set.
Syntax
C7LSC: LS =,{[ OPC =,][ DPC =,][ LSSIZE =,][ NC =,][ NI =,]};
Prerequisites
•
The SS7 link set has already been initiated.
•
All configured SS7 links must be blocked.
Note: After blocking, an SS7 link cannot be unblocked until all the boards processing the SS7 signaling
are blocked and then unblocked.
•
The LSSIZE cannot be set to less than the number of links attached to the link set.
•
DPC must be different across link sets.
•
If SS7MD indicates a 14-bit Point Code, OPC and DPC must be less than or equal to 16383.
•
Only one OPC can exist within a network context.
•
The NC / DPC combination must be different for all link sets.
•
The NC / OPC combination must be different for all link sets.
Attributes
CONFIG
Examples
C7LSC: LS =1, OPC =1, DPC =2, LSSIZE =2;