3 c7lse, 4 c7lsp, C7lse – ccs ss7 link set end – Dialogic SS7G2X User Manual
Page 69: C7lsp – ccs ss7 link set print, C7lse, Ccs ss7 link set end, C7lsp, Ccs ss7 link set print
69
Dialogic
®
SS7G2x Signaling Server SGW Mode User Manual Issue 4
6.6.3
C7LSE – CCS SS7 Link Set End
Synopsis
This command is used to end the SS7 link set.
Syntax
C7LSE:
Prerequisites
•
There should be no signaling links attached to the link set.
•
All configured SS7 links within the system must be blocked.
Note: After blocking, an SS7 link cannot be unblocked until all the boards processing the SS7 signaling
are blocked and then unblocked.
•
There are no C7 Routes using this link set.
Attributes
CONFIG
Examples
C7LSE:
6.6.4
C7LSP – CCS SS7 Link Set Print
Synopsis
This command obtains a printout of the attributes for the SS7 link set. If no link is specified, the values for all
link sets are shown.
Syntax
=,];
Prerequisites
None
Attributes
None
Examples
C7LSP;
Output Format
CCS SS7 Link Set
LS NC OPC DPC NI LSSIZE SS7MD
1 1 1 3 2 2 ITU14
2 2 2 4 0 2 ANSI
EXECUTED