7 cnmop, 8 cnpci, Cnmop – configuration monitor print – Dialogic SS7G2X User Manual
Page 52: Cnpci – configuration pcm initiate, Cnmop, Configuration monitor print, Cnpci, Configuration pcm initiate
52
Chapter 6 Command Definitions
6.5.7
CNMOP – Configuration Monitor Print
Synopsis
This command is used to obtain a print out of the objects being monitored. An object is currently only a
signaling link.
For signaling, the
monitors information sent from the
monitors
information received by the signaling link.
Syntax
CNMOP;
Prerequisites
None
Attributes
None
Examples
CNMOP;
Output Format
Monitoring Configuration
C7LINK STS RTS
1 3-3-1 3-3-2
3 3-3-3 3-3-4
EXECUTED
6.5.8
CNPCI – Configuration PCM Initiate
Synopsis
This command configures a PCM (
) for T1 or E1 operation (
) on a board such that it is available
for signaling or voice. The command optionally configures the PCM to be used as a potential synchronization
source for the system (
). The command also allows the frame format (FF) and line code (LC) to be
Section 7.1.2, “Boards and PCMs” on page 136
for a more detailed description of PCM
configuration.
Syntax
CNPCI:
=,][IDLE=][BM=][
=,];
Prerequisites
•
The board on which the
exists has been initiated.
•
The
has not already been initiated.
•
of E1, the
can be set to HDB3 and the
can be set to G704, CRC4, CRC4C or
CRC4G706.
•
of T1, the
can be set to AMI or B8ZS and the
can be set to SF, ESF or CRC6.
•
of CRC4G706 can only be set on a board type of SS7HDP.
•
The
parameter can only have a value of 0 for E1 and a value of 1 for T1s on boards of a type
other than SS7HDP.
Attributes
CONFIG
Examples
CNPCI:
=1-1,
=1;