9 cnpcc, 10 cnpce, Cnpcc – configuration pcm change – Dialogic SS7G2X User Manual
Page 53: 10 cnpce – configuration pcm end, Cnpcc, Configuration pcm change, Cnpce, Configuration pcm end
53
Dialogic
®
SS7G2x Signaling Server SGW Mode User Manual Issue 4
6.5.9
CNPCC – Configuration PCM Change
Synopsis
This command allows changes to the configuration of a
Syntax
CNPCC:
=,]|[
=,][
=,]};
Prerequisites
•
The
has already been initiated.
•
of E1, the
can be set to HDB3 and the
can be set to G704, CRC4, CRC4C or
CRC4G706.
•
of T1, the
can be set to AMI or B8ZS and the
can be set to SF, ESF or CRC6.
•
of CRC4G706 can only be set on a board type of SS7HDP.
•
The
parameter can only have a value of 0 for E1 and a value of 1 for T1s on boards of a type
other than SS7HDP.
Attributes
CONFIG
Examples
CNPCC:
=1-1,
6.5.10
CNPCE – Configuration PCM End
Synopsis
This command ends the configuration of a
such that it is unavailable for voice or signaling.
Syntax
CNPCE:
=;
Prerequisites
•
No timeslot on the
has been assigned to voice, signaling monitoring or cross connections.
•
The board on which the
exists has been blocked.
Attributes
CONFIG
Examples
CNPCE:
=1-1;