EXFO FTB-8500 Series for FTB-500 - Manual (Page 112)

Creating and Starting a Test Case
98 FTB-8500 Series and FTB-8120NGE/8130NGE
Ethernet BERT Test Case
5. Traffic stream
configuration:
Only Frame Size and
Maximum Rate are
configurable with
Framed Layer 1.
5a. For IPv4, select the
Automatic IP
Address check box
to dynamically
obtain an IP
address from a
DHCP (Dynamic Host Configuration Protocol) server or set the
source and destination IP addresses, Subnet Mask, and the
Default Gateway. Refer to IPv4 Configuration on page 483 for
more information.
5b. For IPv6, set the destination IP address and if required, press the
IPv6 Config button for additional IPv6 settings. Refer to IPv6
Address Configuration on page 485 for more information.
5c. If required, set the network source MAC Address. Select the
Resolve MAC Address check box or set the destination MAC
address. Refer to MAC on page 218 for more information.
5d. Select the Frame Format. Choices are Ethernet II and
802.3 SNAP. Refer to Frame Format on page 218 for more
information.
5e. Select the Enable VLAN check box when required and set the
number of stacked VLAN and its parameters (VLAN Config
button). For more information on VLAN refer to MAC on page 218.
5f. Enter the Frame Size. For more information on Frame Size refer
to Size on page 209.