EXFO FTB-8500 Series for FTB-500 - Manual (Page 131)

Creating and Starting a Test Case
Ethernet and Fibre Channel Application 117
Fibre Channel BERT Test Case
4. Framing configuration (available with FC Framed Layer 2 only):
4a. Set the network parameters. Refer to
Interface Setup (Fibre Channel) on
page 144 for more information.
4b. Select the Login check box to generate
a login process when pressing on the
Login button.
4c. Select the source and destination World
Wide Name (WWN) addresses. WWN
is only available when the Enable login
check box is selected.
4d. Press the Login button to initiate the Login process with the
selected Advertised BB_Credit (refer to page 145). The capability
to log in is available only with Framed Layer 2 when a successful
link has been established.
4e. Press Next.
5. Pattern configuration:
5a. Set the pattern parameters. Refer to
Pattern TX on page 252 for more
information.
5b. Press Finish to complete the test setup.
The Alarm summary tab is
automatically displayed.
6. For additional configuration parameters,
refer to Stream Generation Tabs on page 199.
7. Press the Start button to start the test.
8. For additional results, refer to Traffic Analyzer Tabs on page 159 and
Pattern Tabs on page 251.