Ping configuration, Setup – EXFO FTB-8500 Series for FTB-500 User Manual
Page 408
Advertising
Tools Tabs
394
FTB-8500 Series and FTB-8120NGE/8130NGE
Ping Configuration
Ping Configuration
The Ping tool is used to determine if a network device is reachable. Ping is
not available when no test is created.
Press Tools, Ping, Configuration, and in the Tool list, press Ping.
Note: For Trace Route, see Trace Route Configuration on page 399.
Setup
IP Address/IPv6 Address: Enter the IP address of the network device
to be detected. The IP address version is as per the version selected
during the test setup.
Run: Press Run to start the Ping command.
Configuration
Timeout (ms): Enter the maximum time allowed between an ICMP
echo and response. Choices are 200 ms to 10000 ms. The default
setting is 4000 ms.
Advertising
This manual is related to the following products: