FeiYu Tech FY-Panda2 Autopilot - Manual (Page 19)

Guilin Feiyu Electronic Technology Co., Ltd
Guilin Feiyu Electronic Technology Co., Ltd http://www.feiyudz.cn [email protected]
18
RC setting、SW1&SW2 channel setting
 Panda2 requires a minimum of 6-channel RC receiver.4 Receiver channels are
used for aileron (channel 1), elevator (channel 2) ，throttle (channel 3) and
rudder (channel 4) signal output. 2 free Receiver channels are required to
control the Panda2 Flight Modes (a 3-position switch or dial knob, ‖SW1‖) and
Autopilot Mode (a 3-position switch or dial knob, ‖SW2‖).
 RC mode Setting of your controller has to be fixed wing mode and cancel all
mix control setting.
 Panda2 need two 3-position-switch to control the flight mode.
O ne SW1 used
for setting manual mode, stabilized mode and 3D mode, another one SW2 used
for setting Auto Return To Launch Mode and Waypoint Navigation Flight
Mode
(default) or Auto Circling Mode and Fixed altitude & Heading lock
Mode (Need to setup through the setting software).
 After set up switch mode, you can through switch to the corresponding position
then according to LED flashing situation to confirm whether the setting is
correct or not. the details please see"Pnada2 indicator light instruction"
 SW1&SW2 default setting:
SW1 SW2
Manual Mode Waypoint Navigation Mode
Stabilized Mode NULL
3D Mode Return To Launch Mode