FeiYu Tech FY-Panda2 Autopilot - Manual (Page 33)

Guilin Feiyu Electronic Technology Co., Ltd
Guilin Feiyu Electronic Technology Co., Ltd http://www.feiyudz.cn [email protected]
32
18. After Return To Launch test, please switch SW2 to ―Path Navigation mode‖ to
watch the aircraft according to preset route fly or not.
19.Take off and finish the first flight test.
17. Switch SW2 to Return To Launch (RTL)mode to watch the aircraft automated return to
home or not. Upon reaching the home point it will automatically engage auto circling,
while it waits for your further instructions.
16. Target speed setting(Default setting is 60km/h).The flight speed is very important,
you can not optional Settings. The speed must can keep aircraft keep normal flight. We
suggest not increase the settings too high, it may cause very unusual flying behavior and
may result in damage of your aircraft due to excessive throttling. You can through watch
the ―GPS speed‖ shows on our GCS software and assess the flight cruising speed to set
the target speed. Through—―Param1‖--- ,click on
―set‖. After that, please do not forget to click on
to save the setting to our
Panda2.
Introduction to other functions and
Settings