HITEC Shark User Manual
Page 12
12
Examine your kit carefully!
MULTIPLEX model kits are subject to constant quality checks throughout the production process, and we sincerely
hope that you are completely satisfi ed with the contents of your kit. However, we would ask you to check all the parts
before you start construction, as we cannot exchange components which you have already worked on. If you
fi nd any part is not acceptable for any reason, we will readily correct or exchange it. Just send the component to our
Model Department. Please be sure to include the purchase receipt and a brief description of the fault.
We are constantly working on improving our models, and for this reason we must reserve the right to change the kit
contents in terms of shape or dimensions of parts, technology, materials and fi ttings, without prior notifi cation. Ple-
ase understand that we cannot entertain claims against us if the kit contents do not agree in every respect with the
instructions and the illustrations.
Caution!
Radio-controlled models, and especially model aircraft, are by no means playthings. Building and operating
them safely requires a certain level of technical competence and manual skill, together with discipline and
a responsible attitude at the fl ying fi eld. Errors and carelessness in building and fl ying the model can result
in serious personal injury and damage to property. Since we, as manufacturers, have no control over the
construction, maintenance and operation of our products, we are obliged to take this opportunity to point
out these hazards and to emphasise your personal responsibility.
This model is not made of styrofoam™, and it is not possible to glue the material using white glue or epoxy. Please
be sure to use cyano-acrylate glue exclusively, preferably in conjunction with cyano activator (kicker). We recommend
medium-viscosity cyano. This is the procedure: spray cyano activator on one face of the Elapor®; allow it to air-dry,
then apply cyano adhesive to the other face. Join the parts, immediately position them accurately, and wait a few
seconds for the glue to harden.
Recommended equipment:
Item number
Pieces
Description:
RR
RR+
RTF
Mode 1/3
RTF
Mode 2/4
# 55839
1
Receiver RX-5 M-LINK ID 9
●
# 157321
1
Battery Li-BATT FX 3/1-950 (M6)
●
# 15300/ 15301
1
Transmitter SMART-SX
●
●
# 82523
1
MULTIcharger L-703 EQU
●
●
Optional equipment:
Item number
Pieces
Description:
RR
RR+
RTF
Mode 1/3
RTF
Mode 2/4
# 852727
1
Zacki ELAPOR 20g VE1
●
●
●
●
# 65165
1
Aileron upgrade set
●
●
●
●
# 224327
1
SHARK undercarriage set
●
●
●
●
# 224328
1
SHARK floats set
●
●
●
●
# 224329
1
SHARK landing skid
●
●
●
●
# 73020
1
MULTIlight, 5 LEDs
●
●
●
●
# 92545
1
Combo MULTIcharger LN-3008 EQU w.Mains PSU, AC/DC 230V/12V 5,0A
●
●
●
●
# 92516
1
Charge lead w. high current plug
(M6)
●
●
●
●
Please take care when handling cyano-acrylate adhesives. These materials harden in seconds, so don’t get
them on your fi ngers or other parts of the body. We strongly recommend the use of goggles to protect your
eyes. Keep the adhesive out of the reach of children.
Note: please remove the pictures from the center of the instructions!
GB