Labconco Purifie Horizontal Clean Benches 36125 Series - Manual (Page 18)

14
Product Service 1-800-522-7658
Chapter 3: Getting Started
Removing the Shipping
Skid
LEAVE THE CLEAN BENCH
ATTACHED TO ITS SHIPPING SKID
UNTIL IT IS AS CLOSE TO ITS
FINAL LOCATION AS POSSIBLE.
MOVE THE UNIT BY USING A
SUITABLE FLOOR JACK, OR BY
PLACING A FURNITURE DOLLY
UNDERNEATH THE SKID. DO NOT
MOVE THE BENCH BY TILTING IT
ONTO A HAND TRUCK.
After you verify the clean bench components, move
your clean bench to the location where you want to
install it. Then, follow the steps listed below to remove
the shipping skid from your unit.
To remove the shipping skid:
1. Remove the plastic wrapping and corner posts.
Remove the packaging material from the top of the
bench.
2. Remove and discard the four bolts that secure the
unit to the skid, as shown in Figure 3-1.
)