Labconco Purifie Horizontal Clean Benches 36125 Series - Manual (Page 50)

46
Product Service 1-800-522-7658
Chapter 6: Maintaining Your Clean Bench
5. Install new prefilters by reversing the above steps.
Changing the Fluorescent Lamp:
1. Unplug the Purifier Clean Bench.
2. Remove the prefilters as described earlier in this
chapter.
3. Remove the front dress panel by removing the four
screws located on the top front corners of the panel,
and then lifting the panel up and forward.
4. Remove the lamp reflector by gently squeezing the
reflector to compress it and then lift the reflector
straight up.
5. Remove the lamp by rotating it out of its sockets
and pulling it straight up.
6. Make sure that the surface of the new lamp is clean
and free of dirt or fingerprints, by cleaning its
surface with alcohol or glass cleaner.
7. Install the new lamp by reversing the above steps.
5. Remove the lamp by grasping the plastic endcap on
the left end of the lamp. While supporting the
center of the lamp, push the endcap towards the left.
6. Lift the right side of the lamp up and out of its
socket, and then pull the lamp straight up.
7. Make sure that the surface of the new lamp is clean
and free of dirt or fingerprints by cleaning its
surface with alcohol or glass cleaner.
8. Install the new lamp by reversing the above steps.
Changing the UV Lamp:
1. Unplug the Purifier Clean Bench.
2. The lamp is located on the underside of the canopy,
between the fluorescent lamp and the diffuser.
Remove the UV lamp by rotating it out of its
sockets and pulling it straight down.
3. Make sure that the surface of the new lamp is clean
and free of dirt or fingerprints by cleaning its
surface with alcohol or glass cleaner.
4. Install the new lamp by reversing the above steps.
4' 3'
4' 3'
6'