Labconco Protecto Stainless Steel Perchloric Acid Laboratory Fume Hoods 9682100 User Manual
Page 13
9
Product Service 1-800-522-7658
C
C
H
H
A
A
P
P
T
T
E
E
R
R
3
3
G
G
E
E
T
T
T
T
I
I
N
N
G
G
S
S
T
T
A
A
R
R
T
T
E
E
D
D
Now that the site for your laboratory fume hood is
properly prepared, you are ready to unpack, inspect,
install, and certify your unit. Read this chapter to learn
how to:
• Unpack and move your Protector Perchloric
Acid Hood.
• Set up the fume hood with the supporting
structure and hardboard support.
• Connect to an exhaust system suitable for
Perchloric acid.
• Connect the exhaust washdown to the exhaust
system.
• Connect to the washdown drain.
• Connect the electrical supply source.
• Connect the service lines.
• Seal the Protector Perchloric Acid Hood to the
hardboard support (included).
• Arrange certification of your Protector
Perchloric Acid Hood.
Depending upon which model you are installing, you
may need common plumbing and electrical installation
tools in addition to 5/16", 3/8", 7/16", and 1/2"
wrenches, ratchets, sockets, a nut driver set, a flat-blade
screwdriver, a Phillips screwdriver, and a carpenter
level to complete the instructions in the chapter.
The Protector Perchloric Acid Hood
models weigh between 500 to 700 lbs.
(227-318 kg). The shipping skid
!