Labconco Protecto Stainless Steel Perchloric Acid Laboratory Fume Hoods 9682100 - Manual (Page 17)

13
Product Service 1-800-522-7658
Chapter 3: Getting Started
4. Anchor cabinet(s) with seismic restraints if
required by the local code in your area.
Figure 3-1
5. Secure the hardboard to the top of the base
cabinet(s) using adhesives with the Solvent
Storage Cabinets(s) or mechanical fasteners
with the Acid Storage Cabinet(s). Be sure
the Perchloric Acid drain trough is
accounted for in the relief area of the
hardboard top. See figure 3-2.
6. After completing step 5, apply a sufficient
quantity of adhesive to the top surface of the
hardboard.
7. Place the hood on top of the work surface
and cross support.
8. Place heavy weights on the inside of the
fume hood for approximately 24 hours. This
provides a proper bond of the adhesive.
Protect the hoods work surface from
possible damage by wrapping any weighted
material first.
Step 5
Step 4