Labconco Protecto Stainless Steel Perchloric Acid Laboratory Fume Hoods 9682100 User Manual
Page 22
18
Product Service 1-800-522-7658
Chapter 3: Getting Started
Figure 3-3
All wiring for the fume hood
SHOULD be performed by a licensed
electrician, and conform to all local
codes. In most cases, the hood will
require the use of shielded conduit to
protect the wiring into the hood. The
grounding connection shall not be
made to the terminal box cover.
The fluorescent light has been mounted outside the top
liner panel and is sealed from vapors inside the hood
structure. To change the fluorescent light bulbs in your
hood, you must first remove the front panel from the
hood. Next remove the knock out plugs holding the
light fixture in place. Lift fixture up and replace any
defective bulbs. Reverse order to reassemble.
Internal
Junction Box
Primary I.D. Plate
Secondary I.D. Plate