Laerdal AED Trainer 2 - Manual (Page 5)

EE
NN
GG
LL
II
SS
HH
5
B Baatttte erryy R Re ep pllaacce em me en ntt
To install the battery case into the Laerdal AED Trainer 2, slide the battery case into the trainer's battery receptacle, with
the battery case's label pointed upwards. The battery case locks into place when inserted properly, and the Laerdal AED
Trainer 2 automatically turns on and enters "set-up" mode.
When battery power falls below a certain point, a voice message, "Battery Low," is provided when the Laerdal AED
Trainer 2 is turned on. When this message is heard, replace the batteries as follows:
1. Remove the battery case. Lift the battery case handle up until the two locking tabs release their hold, then
remove the battery case from the Laerdal AED Trainer 2.
2. Replace the alkaline batteries. Lift the lid off of the battery tray by pressing inwards against the locking tab
at the end of the case until it releases (see illustration).
3. Remove the old batteries and install new
LR14 (C-cell) alkaline batteries. Be sure to
follow the battery-placement icons etched
into the inside of the battery case.
4. Reposition the lid, and reinsert the battery
tray into the Laerdal AED Trainer 2.
U Usse e w wiitth h LLaae errd daall T Trraaiin niin ngg M Maan niikkiin nss
The Laerdal AED Trainer 2 can be used with the AED Little Anne and AED Resusci Anne training manikins with Laerdal Link
Technology. This technology allows realistic response to electrode placement on the manikin surface; they also have an LED in
the chest skin indicating the center of correct pad placement. The Laerdal AED Trainer 2 is pre-configured allowing the LED
to light up automatically when pads are attached. If an electrode is loose or incorrectly placed on the manikin, the Laerdal AED
Trainer 2 will repeat the voice prompt to apply the electrode pads.
Note: For use with the AED Little Anne and AED Resusci Anne manikins with Laerdal Link Technology, electrode training pads with
the "Laerdal Link Technology" logo and white connector must be used.
HeartStart training pads (for use with any manikin)
AED Little Anne with Laerdal Link Technology
Training pads for Laerdal AED Training System with Laerdal Link Technology
Remote control for Laerdal AED Trainer 2 (optional)
Programming kit for Laerdal AED Trainer 2 (optional software & cable)
This programming kit provides a selection of three PC Windows based programs
that allow the user to do the following:
1. Creating, editing and uploading of three optional custom-built scenarios to
the Laerdal AED Trainer 2 device.
2. Configuration of the various parameters of the Laerdal AED Trainer 2.
Note: The Laerdal AED Trainer 2 comes with pre-set default parameters that
are identical to the factory settings of the FR 2 AED.
3. Re-programming the Laerdal AED Trainer 2 for localized language output.
Cat. No. 07-10900
Cat. No. 02 00 50
Cat. No. 94 50 90
Cat. No. 94 50 50
Cat. No. 94 50 55
Pull up
Press
A Acccce esssso orriie ess