Laerdal SimMan Essential - Manual (Page 28)

SYSTEM SETUP
28
Opening an Auto Mode Patient Case
to start a simulation in auto mode:
1 Launch the <Instructor Application> on the Instructor PC.
2 Select the Manikin you wish to connect to and click ‘OK’.
3 Click ‘Start Auto Mode Patient Case’. This will open the Patient Case Library.
4 Browse the patient cases using the library menu on the left. The menus can be expanded and collapsed by clicking on the ‘+’ and
‘–’ buttons.
5 Choose a patient case and click ‘OK’.
6 The patient case will open with the simulation being PAUSED. When you are ready to begin the simulation, press the spacebar.
OR
Click the ‘Start session’ button in the bottom left corner of the screen
NOTE: When a simulation is running, the ‘Start session’ button becomes the ‘Pause session’ button. Click this button at any time during
a simulation to pause the session.
SimMan Ess DFU_RevF.indd 28 18.07.12 13:57