Luxul XMS-1024P - Manual (Page 251)

251
User Guide
© 2014 Luxul. All Rights Reserved.
Other trademarks and registered trademarks are the property of their respective owners
Generic Endpoint Device (Class I): The most basic class of Endpoint Device.
Media Endpoint Device (Class II): This class of Endpoint Device supports Media
Stream capabilities.
Communication Device Endpoint (Class III): This class of Endpoint Device supports
end Users of the IP communication system.
The following LLDP-MED optional TLVs are supported in XMS-1024P.
Network Policy TLV The Network Policy TLV allows both Network Connectivity
Devices and Endpoints to advertise VLAN configuration
and associated Layer 2 and Layer 3 attributes that apply to
specified applications on that Port.
Location Identification TLV The Location Identification TLV provides Location
Identification information to Communication Endpoint
Devices based on the configuration of the Network
Connectivity Device it is connected to. If the Location
Identification TLV is included and Location Identification
Parameters are not set a default value is used in place of the
Location Identification TLV.
Extended Power-Via-MDI TLV The Extended Power-Via-MDI TLV is intended to enable
Advanced Power Management between LLDP-MED Endpoint
and Network Connectivity Devices. It allows advertisement
of low level Power requirement details, Endpoint Power
Priority and both Endpoint and Network Connectivity
Device Power status.
Inventory TLV The Inventory TLV contains seven basic Inventory
Management TLVs Hardware Revision TLV, Firmware Revision
TLV, Software Revision TLV, Serial Number TLV, Manufacturer
Name TLV, Model Name TLV and Asset ID TLV. If support
for any of the TLVs in the Inventory Management set is
implemented then support for all Inventory Management
TLVs is implemented.