Rocktron Prophesy II - Manual (Page 38)

3 8
CHORUS Pages
The Chorus effect in the Prophesy is produced by using up to four delayed signals
(referred to here as Voices 1-4), detuning these delayed signals (slightly changing their
pitch), then modulating the detune effect so that the amount of pitch detune is constantly
varying. Using different detune amounts, modulation rates, modulation depths and pan
settings for each delayed signal will produce a greater perceived spaciousness.
Chorus Pages 1 and 2: Voices 1 and 2
122
D
ESCRIPTION
The CHORUS parameter determines whether the Chorus is active or bypassed
for the current preset. (This parameter is displayed only on Page 1.) (Off, On)
The LEVEL parameter determine the volume of Voice 1 relative to the other
voices. (Off, -42.0 to +6.0)
The PAN parameter allows for Voice 1 to be panned to the left or right channel.
(Left to Right)
The DELAY parameter allows you to select the minimum delay time (in
milliseconds) for Voice 1. This delayed signal is detuned and modulated to
produce the chorus effect. Shorter delay times will result in a tighter sounding
chorused signal, while longer delay times will produce a larger ambient effect. (0
to 100)
The DEPTH parameter adjusts the amount of modulation of Voice 1. A lower
depth setting will produce a more subtle detune effect, while a higher setting
results in a more extreme detuning. (0 to 58)
The RATE parameter determines the sweep speed (or the speed at which each
voice is modulated). Lower parameter settings result in slower speeds, while
higher settings result in faster speeds. (0 to 253)
P
ARAMETER
CHORUS
LVL1 and 2
PAN1 and 2
DLY1 and 2
DEPTH1 and 2
RATE1 and 2
Chorus Pages 1 and 2 parameters
CHORUS
ON
RATE1
125
DEPTH1
50
DLY1
68
PAN1
L<26
LVL1
- 2.0