Rocktron Prophesy II - Manual (Page 55)

5 5
Mixer Page 4: Post Effect 3 Mix Levels
122 (PST3-IN MIX)
DIRECT
(EFX 3 OUT)
OFF
D
ESCRIPTION
The PST3-IN MIX parameter determines how much of the signal applied to
the Post Effect 3 effect is direct signal, and how much is effect signal. (100%
Direct to 100% Effect)
The EFX 3 OUTPUT parameter determines the output level of the effect
that is assigned to Post Effect 3. (Off, -42.0 to +6.0)
The EFFECT USED parameter displays the name of the effect that is
currently assigned to the Post Effect 3 location. (Not adjustable)
P
ARAMETER
PST3-IN MIX
EFX 3 OUT
EFFECT USED
Mixer Page 4 parameters
(EFFECT USED)
EMPTY
Application Notes: Post Effect Mixing
The PST2-IN MIX and PST3-IN MIX parameters act as a balance between the direct and effect that
is entering the assigned effect of Post effect blocks 2 and 3. For example, lets say that DUCKER/
DELAY is assigned to Post 1 effect block and that CHORUS is assigned to Post 2 effect block.
Adjusting the PST2-IN MIX parameter to 100% DIRECT would cause only the direct guitar tone to
be chorused while the delayed signal would not be chorused. Adjusting the PST2-IN MIX
parameter to 100% EFFECT would cause only the delayed signal to be chorused while the direct
guitar tone would not be chorused. Adjusting the PST2-IN MIX parameter anywhere between
DIRECT and EFFECT would cause a blend of the direct and the delayed signal to be chorused.
The REV IN (Reverb in) parameter on the following page works the same way.