Rocktron Prophesy II - Manual (Page 74)

74
———————————————————————————————————————————————————
2 Use the control labeled “BASS” to select the controller number that
will be assigned to Prophesy controller page
( 1 ) . To set up a
controller assignment to be used with ADSR, this parameter value
must be set to "
ADSR " rather than a typical controller number. The
" ADSR " controller is located one click past control number " 120 ".
———————————————————————————————————————————————————
3 Use the control labeled “MID” to select the Prophesy parameter that is
to be controlled by ADSR. Here we will select "
WAH FRQ ".
———————————————————————————————————————————————————
4 Use the control labeled “TREBLE” to select the upper limit, which is
typically the highest parameter value that the WAH FRQ parameter is
not to exceed via controller changes sent via ADSR.
For this application, however, we will reverse the upper and lower
limits (as described in the previous section) so that the initial attack will
drop the WAH FRQ parameter to its lowest value, rather than increas-
ing it to its highest value. Set the upper limit to 310Hz.
( 1 ) UPLIM
0
LOWLIM
0
PARM
WAH FRQ
CNTNUM
ADSR
( 1 ) CNTNUM
ADSR
PARM
WAH FRQ
UPLIM
310HZ
LOWLIM
0
( 1 ) CNTNUM
ADSR
PARM
OFF
UPLIM
0
LOWLIM
0