Rocktron Utopia G100 - Manual (Page 59)

59
PARA1 PEDAL VOLUME
Turn the PARAMETER SELECT knob for the first parameter of the Controller Assign
function. This parameter allows you to select a controller number for the NUMB 1
parameter to respond to. Step 2
Step 1 To access the Pedal Controller function, turn the FUNCTION SELECT knob clock-
wise to "PEDAL CONTROLERS".
PEDAL CONTROLER
3,5,7,9 12 2,4,6,8,10 1
NUMB 1 XXX
NOTE: This parameter (NUMB 1 only) also gives you the option of selecting "ADJ". When "ADJ" is
selected, the parameter assigned to the first controller (NUMB 1) can be instantly accessed by turning
the PARAMETER ADJUST knob when the preset title is displayed. This allows you to access a pa-
rameter that you adjust frequently without paging through function headings and parameters. If you
select "PED" the parameter assigned to the first controller (NUMB 1) will be adjusted by the built-in
expression pedal. If you select "OFF" the first controller will not be assigned to either the "ADJ or the
PED".
Step 5
Step 4
Step 3 Use the PARAMETER ADJUST knob to select the controller to be assigned to the
NUMB 1 parameter (either ADJ, PED or OFF).
NUMB 1 ADJ
Use the PARAMETER ADJUST knob to scroll through the available parameters to be
assigned to the PARA 1 parameter.
Turn the PARAMETER SELECT knob to select "PARA 1". This parameter allows you
to select a parameter for the NUMB 1 parameter to respond to.
The "Pedal Controllers" function allows for specific UTOPIA G100 adjustable parameters to be
mapped (or assigned) to the built-in expression pedal for real-time control over the selected
parameter. The Pedal Controllers option lets you assign one controller for "quick adjust" or assign
one or two parameters to the built-in expression pedal. The Pedal Controllers also lets you store
an upper and lower parameter value limit which the controller cannot exceed. For example, when
using the expression pedal to send continuous control changes to control the "PITCH" parameter,
an upper limit of +300 can be set and a lower limit of -200 can be set — even though the actual
parameter range available is from +1200 to -2400. When the expression pedal is at its heel
position in this example, the "PITCH" parameter will be at -200, while at its toe position it will be at
+300. Up to two controllers can be assigned for each individual preset.
Pedal Controllers
PARA1 XXXX