Rocktron Utopia G100 - Manual (Page 63)

63
Step 2 Turn the PARAMETER SELECT knob one step clockwise to the RUN STAT
parameter.
Step 3
Step 4
Turn the PARAMETER ADJUST knob to select ON for the RUN STAT param-
eter.
RUN STAT OFF
RUN STAT ON
Turn the PARAMETER SELECT knob one step clockwise to the PEDAL VOL-
UME parameter.
Step 5
The PEDAL VOLUME parameter displays the current preset volume as deter-
mined by the pedal position. Move the expression pedal up and down and you
will see the volume values change as the pedal moves.
PEDAL VOLUME 127
You now must store your changes. If you have made any changes to any param-
eter, the LED above the "STORE" button will light. Press the STORE button to save
the changes you have made. "STORE AT PRESET" will flash intermittently with the
current preset. If you would like to save this change to the current preset, press the
STORE button again. To save this adjusted preset (and the parameters you have
just changed) to a different preset location, use the PRESET SELECT knob to
choose the preset destination and then press the STORE button again. Note that
doing this will "over-write" the preset location you are saving to.
STORE AT PRESET CURRENT PRESET
Pedal Status......continued.............