Rocktron Utopia G100 - Manual (Page 7)

7
STEP1 Turn ON the UTOPIA G100.
STEP 2 Scroll through the presets by pressing the DOWN button. You may
also do this by following STEP 3.
STEP 3 Scroll through the presets by pressing the UP button. You may also
do this by following STEP 2.
STEP 4 Recall the preset you have scrolled to by pressing the RECALL
button. NOTE, holding the RECALL button down for two seconds
will MUTE the output of the UTOPIA G100. To disengage the MUTE,
hold the RECALL button down for two seconds.
STEP 5 Use the built-in expression pedal to change the parameter(s) in real
time that are assigned to the pedal controller function,
STEP 6 You may also select a preset by turning the PRESET SELECT
knob. Note, that this knob automatically recalls the preset, you do
NOT need to press the recall button.
STEP 7 Turn the FUNCTION SELECT knob to the desired effect or utility
function.
STEP 8 Turn the PARAMETER SELECT knob to the parameter you wish to
alter under the selected effect or utility function
.
STEP 9
Use the PARAMETER ADJUST knob to select the new parameter
value.
STEP 10 Press the STORE button to start the storing procedure. If you wish
to save the altered preset in the current preset location, press the
STORE button a second time. If you wish to store the altered preset
in a different preset location, turn the PRESET control to the desired
preset number, then press STORE a second time.
Quick Reference....continued...