Rocktron Utopia G100 - Manual (Page 60)

60
Step 6
Step 7
Turn the PARAMETER SELECT knob one step clockwise to display the Upper
Limit parameter (for PARA 1).
Step 8
Use the PARAMETER ADJUST knob to choose the highest value that the pa-
rameter is not allowed to exceed when the toe of the expression pedal is down.
Step 9
ULIM C1 127
Step 10
Step 11
NOTE: Parameters available to be assigned may vary depending on what configuration "CONFIG SELECT" you have
choosen for that particular preset.
Turn the PARAMETER SELECT knob one step clockwise to access the Lower
Limit parameter (for PARA 1).
NOTE: Because character space on the display is limited, you may not see the entire name of a parameter. For
example, to choose FLANGER LEVEL 1 or FLANGER PAN 1 (or any of the Flanger's parameters), select "LEVEL
1" or "PAN 1" parameter that immediately follows the "FLANGER" parameter when turning the PARAMETER
ADJUST knob clockwise. This is true for some other parameters as well.
LLIM C1 50
LLIM C1 0
Use the PARAMETER ADJUST knob to select the lowest value which the
parameter is not to fall below through when the heel of the expression pedal is
down.
ULIM C1 XXX
NOTE: The UTOPIA G100 allows you to select an upper and lower value limit which the parameter cannot
exceed. For example, if a parameter has a value range from 0 to 127, yet you would like the range of the
parameter to vary from only 50 to 127, you may set a lower limit of 50 and an upper limit of 127 via the Upper
(ULIM) and Lower Limit (LLIM) parameters. When a parameter is stored in the Pedal Controller function
(Step 7), the maximum parameter value is automatically stored as the upper limit (expression pedal toe down),
while the minimum value is stored as the lower limit (expression pedal heel down).
To make changes to the second Pedal Controller turn the PARAMETER SE-
LECT knob clockwise one click.
NUMB 2 XXX
Repeat steps 3-10 to make changes to NUMB 2, PARA 2, ULIM C2, and LLIM
C2
Selecting a lower limit value that is greater than the upper limit value will invert the response of
the controller - i.e. the toe position of the expression controller will provide the minimum value,
while the heel position will provide the maximum value.