SpectraCal EIZO ColorEdge User Manual
Page 10
17544 Midvale Avenue N., Suite 100, Shoreline, WA 98133 USA
Corporate: +1 206 420 7514 | Tech Support: +1 206 457 8949
c. Monitor Optimization
Perform this RGB Gains calibration step only if the Eizo monitor does not have a full 1D LUT
available. An available 1D LUT will be calibrated on the following CalMAN page.
On the Monitor Optimization page, you can optimize the Eizo monitor’s RGB Gain and RGB Black
Level controls. There is no need to set the Eizo Color Temperature control, as it is automatically
set to User when the RGB controls are adjusted. Click the CalMAN AutoCal button and select
“2 Point 30, 100%” to automatically adjust these grayscale controls.
d. Internal Monitor Calibration
On the Monitor Optimization page, CalMAN automatically adjusts the Eizo monitor’s output 1D
LUT to calibrate gamma and adjusts its color matrix to calibrate CMS. Click the CalMAN AutoCal
button to start the automatic calibration process.
Note: If the Eizo monitor does not have an internal 1D LUT, use the previous CalMAN page to
calibrate the monitor’s RGB Gain controls.
e. ICC Profile
On the ICC Profile page, CalMAN automatically measures the Eizo monitor’s color primaries and
its grayscale levels. It then creates an ICC profile that it writes to the computer that is driving the
Eizo monitor. Click the CalMAN AutoCal button to start the automatic ICC profile process.
f. Calibration Results
On the Calibration Results page, CalMAN displays the monitor measurement data from the
previous Pre-Calibration Capture page. It also automatically measures the monitor’s post-
calibration performance and displays the results for comparison. Click the CalMAN Read Series
button to start the post-calibration measurement.
g. Visual Verification
On the Visual Verification page, CalMAN displays comparison chip charts for the monitor’s pre -
calibration and post-calibration grayscale performance and ColorChecker performance. It also
displays a variety of photo images on the calibrated display, with the option to disable the ICC
Profile for comparison.
DONE – You are done with the 1D LUT/CMS/ICC monitor calibration for an EIZO monitor that i s normally
connected to a computer’s standard graphics adapter output.