SpectraCal EIZO ColorEdge - Manual (Page 8)

17544 Midvale Avenue N., Suite 100, Shoreline, WA 98133 USA
Corporate: +1 206 420 7514 | Tech Support: +1 206 457 8949 | www.spectracal.com
Back to Top
Graphics Adapter Connection Mode Calibration
Calibrate 1D LUT, Color Matrix, and ICC Profile, or
Calibrate RGB Gains, Color Matrix, and ICC Profile
Follow this procedure to automatically create and load an optimized 1D LUT monitor calibration file (or
adjust RGB Gains), adjust the color matrix, and then create an ICC profile for an Eizo monitor that is
normally connected to a computer’s standard graphics adapter output.
To instead create a 3D LUT file, click the following link to jump to the 3D LUT calibration section, above.
Note: If you have already calibrated the Eizo monitor with a 3D LUT, the monitor calibration is complete.
You should not attempt to also create a 1D LUT for the monitor.
Monitor - Direct (EIZO/HP) Workflow
The Monitor - Direct (EIZO/HP) workflow in CalMAN is used to automatically create a 1D display
calibration LUT, adjust the color matrix, and create an ICC profile. To open this CalMAN workflow, in the
main menu select Open Workflow Template / Monitor - Direct (EIZO/HP). Proceed through the
instructions in each step of the Monitor Direct workflow, using the following notes for EIZO monitor
specifics.
1. Base Settings section
In the Base Settings section of the Monitor - Direct (EIZO/HP) workflow,
step through the following pages:
a. Calibration Client Connect
To connect to CalMAN Client 3 on the local computer on which
CalMAN is running, in order to calibrate an Eizo monitor on the
local computer, click the “Local Client Connect” button. CalMAN
will automatically connect to the locally installed CalMAN Client 3
as a Source device and as a Display Control device.
To connect to CalMAN Client 3 on another computer on the local
network, in order to calibrate an Eizo monitor on that computer,
click the “Networked Client Connect” button. On the Source
dialog, under Manufacturer, select “SpectraCal.” Under Model, select “SpectraCal – CalMAN
Client 3 Pattern Source.” In the Socket Connection search box, select the IP address for the
desired target computer, and then click Connect.
Note: The Eizo internal test patterns are not an advantage in this situation, and cannot be used
on an Eizo monitor that is being used as a workstation’s primary display.
Note: Because the Eizo monitors have only one 1D LUT per input, there are no selections
available in the Select Monitor and Calibration Memory drop down on this Calibration Client
Connect page.