Calibrate 3d lut – SpectraCal EIZO ColorEdge User Manual
Page 11
17544 Midvale Avenue N., Suite 100, Shoreline, WA 98133 USA
Corporate: +1 206 420 7514 | Tech Support: +1 206 457 8949
Independent Source Mode Calibration
Calibrate 3D LUT
Follow this procedure to automatically create and load an optimized 3D LUT monitor calibration file into
an Eizo monitor that is normally connected to an independent signal source, such as a signal router or
video adapter device (not directly connected to a computer’s standard graphics adapter output).
To instead create a 1D LUT and adjust the color matrix, click the following link to jump to the
Color Cube (3D LUT) Workflow
The Color Cube workflow in CalMAN is used to create display calibration 3D cube LUTs. In the CalMAN
main menu, select Open Workflow Template / Color Cube (3D LUT). Proceed through the instructions in
each step of the Color Cube workflow, using the following notes for EIZO monitor specifics.
1. Initial Setup section
In the Initial Setup section of the Color Cube workflow, step through the
following pages:
a. Session Setup - Meter Connect
For monitors without a supported built-in meter, connect your
external color meter to the CalMAN computer.
On the Session Setup page, click the Find Meter button. On the Find
Meters dialog, select either your Eizo display meter, or your externally
connected meter if it is listed, then click Search. If your external color
meter is not listed on the Find Meters dialog, just click Search.
Under the Target Display Type drop down, if the Eizo monitor has
wide color gamut that “reproduces 97% of Adobe RGB color space,”
select “LCD (LED Wide Gamut).” If the monitor is not wide gamut,
select “LCD (LED).”
b. Session Setup - Source Connect
For Eizo monitors that provide internal test patterns (listed above), on the Session Setup page,
click the Find Source button. On the Source dialog, under Manufacturer, select “Eizo.” Under
Model, select “Eizo – ColorEdge monitors.”
For cases where you can’t or don’t wish to use EIZO internal test patterns, use a hardware test
pattern generator as the source.
c. Session Setup - LUT Device Setup
On the Session Setup page, click the Find 3D LUT Device button. On the Display dialog, under
Manufacturer, select “Eizo.” Under Model, select “Eizo – ColorEdge monitors 3D LUT.”