SpectraCal EIZO ColorEdge User Manual
Page 4
17544 Midvale Avenue N., Suite 100, Shoreline, WA 98133 USA
Corporate: +1 206 420 7514 | Tech Support: +1 206 457 8949
Note: Because the Eizo monitors have only one 3D LUT per input, there are no selections
available in the 3D LUT Memory drop down, on the LUT Device Setup page.
Also on the Display Control tab, select the Display Mode that corresponds to the monitor input
that you are calibrating. See the table below:
Eizo Monitor
Display Mode
CG222W, CG232W, CG242W
Cal – for all inputs
CG223W, CG243W, CG245W
CAL1 – for DVI-1
CAL2 – for DVI-2
CAL3 – for DisplayPort
CG275W
CAL1 – for DVI
CAL2 – for DisplayPort-1
CAL3 – for DisplayPort-2
CG246, CG276
CAL1 – for DVI
CS230*, CX240*, CX270*
CAL2 – for DisplayPort
CAL3 – for HDMI
*3D or 1D LUT available only with Eizo ColorNavigator license
Note: On some Eizo monitors, there are additional display modes available, which are global
across all inputs. These additional modes do not support 3D LUT calibration.
d. Session Options page
On the Session Options page, be sure to select the Input Signal Levels, either Video (16-235) or
PC (0-255), which matches the signal levels that are normally supplied to the monitor input that
you are calibrating.
2. Display Pre-Test section
In the Display Pre-Test section of the Color Cube workflow, you can measure the performance of a
display before you calibrate it, on the Gamma & ColorChecker page and on the Advanced Linearity page.
On the Performance Analysis page, these monitor measurements are then evaluated in a series of
pass/fail performance parameters.
If the monitor fails in any of these parameters, you should consider using the following Display
Optimization section of the workflow to optimize adjustments on the monitor itself.