SpectraCal EIZO ColorEdge - Manual (Page 13)

17544 Midvale Avenue N., Suite 100, Shoreline, WA 98133 USA
Corporate: +1 206 420 7514 | Tech Support: +1 206 457 8949 | www.spectracal.com
If the monitor passes all of these parameters, you can skip the Display Optimization section of the
workflow and go immediately to the Display Calibration section of the workflow.
3. Display Optimization section
In the Display Optimization section of the Color Cube workflow, you are guided to optimize monitor
settings for picture mode, color gamut, color temp, gamma, dynamic range, white point balance, and
white point luminance.
On the RGB Adjust page, under the RGB Adjust Levels selection, select “2 Point 30, 100%.” Click Read
Continuous and adjust the monitor’s RGB Gain controls for RGB balance at 100%.
4. Display Calibration section
In the Display Calibration section of the Color Cube workflow, there are provisions for calibrating both a
1D RGB LUT (1D Ramp LUT page) and a 3D cube LUT (3D Cube LUT page). When we are calibrating an
EIZO monitor with a 3D LUT, we will skip the 1D Ramp LUT page and use only the 3D Cube LUT page.
Note: Eizo monitors can be calibrated with either a 1D LUT or a 3D LUT (supported models), but not bo th.
c. 1D Ramp LUT page
Skip over the 1D Ramp LUT page when creating a 3D LUT file for an EIZO monitor.
d. 3D Cube LUT page
On the 3D Cube LUT page, click the AutoCal (rotating arrows) button at the right end of the
meter action buttons. The following AutoCal Setup dialog then appears:
a) For File Format, select “3DL – common .3dl formats.”
b) For Output Cube Size, select “17 Points.”
c) For Bit Depth, select “16.”
d) For Cube 3D LUT Settings, select your desired number of cube optimization points.
e) Click the OK button to initiate the 3D cube LUT calibration process.