VDO WL X3 DW - Manual (Page 20)

X3DW VDO CYCLECOMPUTING 38 www.vdocyclecomputing.com X3DW 39
I F D GB D GB
To wake it up out of despatch mode, press the
button simultaneously for a few seconds.
The computer is now ready for use and tells you
so by showing the language setting.
See also Chapter 4.4
4.2 Switching on the computer for the first time >>> P02, Display see Chapter 4.4
Waking up from despatch mode
The computer is delivered with a battery installed.
To reduce the battery consumption, the computer
is put into despatch mode. The display is empty
(no display).
4.3 Installing the battery in the computer >>> P05
4.4 Language setting after battery change
Your VDO computer is supplied with a 3V battery
(type 2032).
The battery is already installed when supplied.
To change the battery, proceed as follows:
After inserting the battery, your VDO computer
automatically welcomes you in the English main
menu.
LANGUAGE ENGLISH.
Confirm with
M .
ENGLISH SELECT OK? Confirm with M .
step 1 Place the battery in the computer casing
with the +terminal facing up.
Step 2 Make sure that the battery does not
get wedged.
Computer confirms:
LANGUAGE SELECT DONE.
Automatic return to SETTINGS/SELECT.
You are now in function mode. If you do not want
to make any more settings, you can recall the func-
tions using . If you want to make further
settings, confirm SETTINGS/SELECT with
M .
When the battery is changed, all settings and the
total kilometres cycled are saved.
must point to the spokes.
Depending on the room available, the transmitter
can be fitted at the front on the forks, inner side
of the fork or backside of the forks.
>>> P04
step 2 Place spoke magnet around an outer
spoke. The silver middle of the magnet points
towards the transmitter. Align the magnet to the
sensor mark on the transmitter with a gap
of about 1 – 5 mm.
Step 3 Align transmitter and magnet for good and
fasten in place: Pull cable ties tight and push
magnet in firmly.
Step 4 Decide whether fitting to handlebar or
stem and turn the base of the handlebar holder
by 90° accordingly. To do so, undo the screws in
the holder, take out the foot and turn it 90°, insert
and tighten the screws again.
ATTENTION: Do not over tighten screws.
step 5 Guide the cable ties through the slot in the
handlebar holder, place around the handlebars
or the stem and pull (do not pull tight just yet).
Step 6 If fitting to handlebar: Align computer
angle to achieve optimum readability. Now pull
cable ties tight. Snip off protruding ends with
clippers.
step 3 Take care that the rubber seal lies flat on
the battery compartment lid.
Step 4 Insert the battery compartment lid into the
opening and turn it with a coin to the right as far
as it will go (approx. 1/3 turn).
TIP for changing battery: VDO recommends chang-
ing the battery once a year. Buy a new battery in
good time to ensure the wireless transmission
works perfectly. When the battery is changed,
all settings and the total kilometres cycled
are saved.
4.5 Placing the computer into the handlebar holder >>> P06
The VDO twist-click system fastens the computer
securely with the handlebar holder.
Step 1 Place computer into the holder in
10 o‘clock position.
Step 2 Twist computer to the right to 12 o‘clock posi-
tion and click into the holder system.
Step 3 To take the computer out, twist to the left
(do not push or pull).
How to remember: Rigid to the Right, Loose to the Left
I F