Vortech 2006-2010 6.1L Hemi Cars (Charger, Challenger, Magnum, 300C) - Manual (Page 16)

P/N: 4CL020-010 v6.0, 02/28/2012
©2012 Vortech Engineering, Inc.
All Rights Reserved, Intl. Copr. Secured
2
Fig. 1-a
1I. FRONT FASCIA REMOVAL
1. Remove the plastic splash pan on the bottom of
the vehicle.
2. Remove the electrical plug for the fog lights
located on the passenger side of the vehicle.
3. Remove the plastic rivets securing the inner
fender liners (new rivets are supplied for re-in-
stallation).
4. Locate the two 10mm headed screws in the
front outer edge of the inner fender (one on
each side of the vehicle) (See Fig 5.A-1.
Remove the screws and set aside to be rein-
stalled in a later step.
5. Locate and remove the four 10 mm nuts (Two
on each side of the vehicle) (See Fig 5.A-2)
6. Remove the two covers from the top of the fas-
cia (See Fig 5.A-3)
7. Remove the six plastic retaining clips securing
the top of the fascia to the radiator core sup-
port.
8. Gently pull the corners of the fascia way from
the fenders. And remove the fascia.
9. Remove the plastic clips retaining the inner fas-
cia support. And remove the inner fascia sup-
port. (See Fig 5.A-4, 5.A-5)
(300C and 2008 Magnum: skip to section 2.
All others proceed as follows)
10. Remove the three 8 mm headed screws from
the drivers side headlight.
11. Pull the headlight straightforward and remove.
12. Remove the two head light plugs. And set the
head light assembly aside.
Fig. 5.A-1 (Challenger Shown)
Fig. 5.A-2 (Challenger Shown)
Fig. 5.A-3 (Challenger Shown)
10MM STUDS