Vortech 2006-2010 6.1L Hemi Cars (Charger, Challenger, Magnum, 300C) - Manual (Page 35)

P/N: 4CL020-010 v6.0, 02/28/2012
©2012 Vortech Engineering, Inc
All Rights Reserved, Intl. Copr. Secured
21
A. Reconnect the battery.
B. Locate the vehicles OBD2 connector located
below the dash on the driver’s side of the
vehicle.
C. Attach the OBD2 connector from the Flash
tool that is provided in the kit to the vehicle’s
OBD2 port. Make sure this connector is seat-
ed all the way in the vehicle’s OBD2 port. You
do not want this connector coming out during
programming or damage may occur to the
vehicle’s ECM.
D. The Reflash tool should power up and display
three parameters.
1. Performance Tune
2. Diagnostics
3. Options
E. Select “Performance Tune” and press the
enter button in the middle of the arrow keys.
F. Read the disclaimer entirely, then select
agree and press ENTER.
G. At this point follow the instructions on the
screen displayed on the reflash tool. If you
have any questions, either refer to the manu-
al that is provided with the reflash tool or con-
tact our service department for further assis-
tance.
H. Turn the ignition on (do not start the vehicle).
Set the parking brake and press the ENTER
button to continue.
I.
SELECT TUNE will be displayed at the top of
the screen. Use the arrow keys to select the
appropriate tune for your vehicle and press
the ENTER button. You will have a choice of
two to choose from:
1. Vortech (used for installing kit)
2. Original Backup
J. Continue to follow the screen and when fin-
ished, unplug the reflash tool from the vehi-
cle’s OBD2 port.
IMPORTANT! To ensure trouble-free programming of your vehicle's computer:
• Make sure the vehicle's battery is sufficiently charged.
• Turn off all accessories and close doors to prevent unnecessary drain on the battery.
• Do not attempt to program your vehicle while a battery charger is connected.
• Improper battery voltage will result in failure of the programming process.
• Do not disconnect the cable or turn off the ignition during programming.
NOTE: Do not disturb the cable, or turn
the ignition off during this time.
If the programming is disrupted,
the computer will not start or
run your vehicle!
Fig. 12-a
ESCAPE
ENTER
OR
SELECT
ARROWKEYS
12. REFLASH COMPUTER