Vortech 2006-2010 6.1L Hemi Cars (Charger, Challenger, Magnum, 300C) - Manual (Page 22)

P/N: 4CL020-010 v6.0, 02/28/2012
©2012 Vortech Engineering, Inc.
All Rights Reserved, Intl. Copr. Secured
8
A. (This step applies to 300C and 2008
Magnum vehicles only. All others skip
to step B) Install a ½” breather hose from the
engine to the hole in the air filter using the sup-
plied barbed fitting. Insert the air filter into the
space behind the driver side headlight for later
attachment to the supercharger inlet. (See Fig.
5-a)
B. Install the supplied 3” aluminum idler in the
lower 3/8-16 hole for the 6.1L and in the up-
per 3/8-16 hole for the 5.7L. Make sure that
the snap ring side is facing forward (away
from the mounting plate). (See Fig. 5-b).
2009-2010 5.7L Challenger models will use
inner most hole on mounting plate for idler
pulley.
C. Install the supplied power steering pump pulley
on the already installed hub using the supplied
1/4” hardware.
D. Install the supplied accessory drive belt (as
shown in Fig. 5-c).
E. Position the supercharger in front of the mounting
plate assembly in front of the engine and install
and tighten the four 3/8” x 1 ¼” bolts.
F. (This step applies to 300C and 2008
Magnum vehicles only. All others skip
to step G) Install the air filter onto the super-
charger inlet and tighten the clamp.
G. Install the supplied gilmer (toothed) belt around
the pulleys on the mounting plate assembly.
H. Using the supplied M12 x 100mm bolt, install
the supplied 3.5” aluminum idler with the bearing
retaining snap ring pointed towards the front of
the vehicle. The screw should pass through a flat
washer, S/C mounting plate, 1.55” idler spacer,
the idler, thick bearing washer, lock washer and
nut. Install the supplied nut and lock washer on
the end of the screw and tighten the idler so that
the gilmer belt is snug. (See Fig. 5-d).
I. Secure the remote drain hose away from the
belt and hoses using tie-wraps.
5. SUPERCHARGER INSTALLATION
Fig. 5-b
Fig. 5-d
NOTE: ½” hose should point towards the pas-
senger side and then back under the
supercharger plate and up to the manifold
port.
Fig. 5-a
TRIM AS
NECESSARY TO
PROVIDE AIR FILTER
CLEARANCE ON
DODGE MAGNUM
BEND THESE LINES TO
PROVIDE AIR FILTER
CLEARANCE ON
DODGE MAGNUM
Fig. 5-c
6.1L
2005-2008 5.7L
2009 5.7L