Vortech 2006-2010 6.1L Hemi Cars (Charger, Challenger, Magnum, 300C) - Manual (Page 25)

P/N: 4CL020-010 v6.0, 02/28/2012
©2012 Vortech Engineering, Inc
All Rights Reserved, Intl. Copr. Secured
11
7. CHARGE AIR COOLER CORE AND SURGE TANK INSTALLATION
1. Using sealant, install two “short” 90 degree fittings
(two of the supplied 90º fittings have shorter hose
barbs than the others) into the CAC end tank. Point
the upper one horizontally towards the driver side
and point the lower one down. (See Fig. 7-a)
2. Install a 90º fitting into the bottom of the surge
tank and point it towards the front of the vehicle.
Install a straight fitting into the side of the surge
tank.
3. Attach the supplied surge tank to the strut tower
using the supplied bracket and ¼-20 x ½” socket
head cap screws (See Fig. 7-b).
4. Install molded 90º hoses onto the barbed fittings
on the CAC core and point them forward.
5. Lower the CAC into place over the driver side
valve cover.
6. Attach the 90º hose connected to the upper fit-
ting on the cooler end tank to the straight fitting
installed in the side of the surge tank (trim hose
as needed).
7. Verify that all water hose connections have tight-
ened clamps installed.
8. Trim the strut top cover as needed and reinstall.
(See Fig 7-c).
Fig. 7-b
Fig. 7-a
Fig. 7-c