Altera Stratix IV GT 100G - Manual (Page 33)

Chapter 6: Board Test System 6–11
Using the Board Test System
October 2010 Altera Corporation Stratix IV GT 100G Development Kit User Guide
The SSRAM Tab
The SSRAM tab allows you to read and write SRAM and flash memory on your
board.
Figure 6–6 shows the SSRAM tab.
The following sections describe the controls on the SSRAM tab.
Read
The Read control reads the SSRAM on your board. To see the SSRAM contents, type a
starting address in the text box and click Read. Values starting at the specified address
appear in the table. The SSRAM addresses display in the format the Nios II processor
within the FPGA uses, that is, each SSRAM address is offset by 0x00200000. Thus, the
first location in SSRAM appears as 0x00200000 in the GUI.
1
If you enter an address outside of the 0x00200000 to 0x003FFFFF SSRAM address
space, a warning message identifies the valid SSRAM address range.
Figure 6–6. The SSRAM Tab