The sfpa tab, The sfpa tab –20, Start –20 stop –20 – Altera Stratix IV GT 100G User Manual
Page 42
Advertising
6–20
Chapter 6: Board Test System
Using the Board Test System
Stratix IV GT 100G Development Kit User Guide
October 2010
Altera Corporation
The SFPA Tab
The SFPA tab allows you to do loopback testing on this interface using different data
patterns, PMA settings, and clock speeds using the Clock Control application.
Figure 6–10
shows the SFPA tab.
1
You must have the SFPA loopback module installed on your 100G development board
for this test to work correctly.
The following sections describe the controls on the SFPA tab.
Start
The Start control initiates the SFPA loopback test.
Stop
The Stop control terminates the SFPA loopback test.
Figure 6–10. The SFPA Tab
Advertising