Dish Network Duo 322 - Manual (Page 16)

Page 11
Remote Control
Telephone Jack
Connect a telephone cable with a standard RJ-11 telephone connector
to the receiver here, and then connect the cable to an active telephone
line.
Note: The receiver must be connected at all times to an active telephone line.
Remote Control
The remote control gives you easy access to the features of your satellite
receiver.
Basic remote control setup is explained here, using the SAT button on the
remote.
Complete instructions on how to use the remote, as well as the rest of the
system, are in Chapter 3.
Tip: If you have
the receiver
connected to a
DSL (Digital
Subscriber Line)
phone line and it
cannot dial out,
you may have to
install a DSL filter
between the
receiver and the
telephone jack
on the wall.