Dish Network Duo 322 - Manual (Page 18)

Page 13
Remote Control Settings
Remote Control Settings
Change the Address
The remote control and receiver can operate on any one of 16 addresses;
however, they must both be on the same address for the remote to control the
receiver. This section explains how to change the address in both devices.
Note: Do not change the address of the remote unless absolutely necessary
because the remote cannot control the receiver if the two devices have different
addresses.
1. Press SYS INFO button on your remote control. The System
Information screen displays and shows the Remote Address.
Write down this address: _____________
2. Press and hold the SAT button on your remote control for about
three seconds, until all of the mode buttons light up, and then let
go of the SAT button.
3. Use the NUMBER PAD buttons to enter any num-
ber between 1 and 16, but not the one you wrote in
step 1.
Write down the number you entered:___________
4. Press the POUND (#) button. If you entered the
address correctly, the SAT mode will flash three times.
5. Press the RECORD button.
Note: Make sure the Remote Address you see on the
System Information screen is the same as the one you
entered in step 3. If it isn't, the remote cannot control the
receiver.
6. Press the SELECT button to close the System Information
screen.
Checking the Remote Control Address
1. Press and hold the SAT mode button for three seconds, until all
of the mode buttons light up, and then let go of the SAT button.
2. Press the POUND (#) button twice. The SAT mode button will
flash the same number of times as the address number (for
example: three flashes means address 3).