Dish Network Duo 322 - Manual (Page 29)

Page 24
Chapter 3
Using the System
Recover Button
Press the RECOVER button if you accidentally change the
channel or video input on your TV and cannot get the picture
back from your satellite receiver. When you press the
RECOVER button as described below, the remote control sends commands
to your TV to change channels or video inputs to try to get you back to
watching satellite programming. This procedure works only if you have
accidentally changed the TV channel or video input. It does not recover lost
satellite signal (See Chapter 4 - Reference for troubleshooting information).
RECOVER only works if the remote control has been set up to control the
TV and/or VCR, if connected.
Note: You may need to press the RECOVER button up to 30 times to
recover your satellite TV video.
1. Press and hold the RECOVER button until all four mode buttons light,
and then let go of the button. The SAT mode button flashes twice and
then all four mode buttons flash three times.
2. Press the RECOVER button. Wait for the TV mode button to flash
once and then all four mode buttons to flash once.
3. If you see the Important System Information screen, press the
SELECT button to close the screen. You have recovered your satellite
video.
4. If you do not see the Important System Information screen, repeat
steps 2 and 3 until you have recovered your satellite video.
Changing Channels
There are three basic ways to change channels while watching a program:
• Press the remote control UP or DOWN ARROW
buttons to get to the desired channel.
• Use the remote control NUMBER PAD buttons to enter
the desired channel number.
• Press the GUIDE button and select a program from the
Program Guide. See page 27 for more information.
Using the Menus
Menus displayed on the TV screen make using the receiver and selecting
programs quick and easy. Use the menus to control the receiver and to use
its features such as; setting locks, choosing a program, or creating a
Favorites List.
Tip: The channel
you select may
display one of
several program
information
symbols. If the
program is on a
channel that is
not part of your
subscription, the
channel will be in
red.