Dish Network Duo 322 - Manual (Page 26)

Page 21
Chapter 3
Using the System
Using the Remote Control
This section describes how to use the remote control in the SAT mode to
control your satellite receiver. If you want to use the remote to control your TV
and other devices, see Control Other Devices with the Remote later in this
chapter.
Sat Mode Button
Press this button to set the remote to SAT mode, to control the
receiver. The SAT mode button's back light turns ON briefly to show
that the remote is set to SAT mode.
Note: Make sure to keep the remote in SAT mode to use the buttons that are
described here.
Power Buttons
Press the blank POWER button to turn the receiver ON or
OFF. Press the TV POWER button to turn the TV ON and
OFF even when the remote control is in SAT mode.
Note: You must program the remote to control your TV for the TV POWER
button to work as described. See Control Other Devices with the Remote later in
this chapter.
Menu Button
Press this button to open the Main Menu.
Page Up And Page Down (Arrow) Buttons
Press the PAGE UP button or the PAGE DOWN button to scan,
page by page, through the Program Guide , a Theme
Categories list, a Favorites List, an Event Timers list, or a list
of channels.
Mute Button
Press this button to turn off the TV sound. Press it again to restore
the TV sound.
Note: You must program the remote to control your TV for both the
VOLUME and MUTE buttons to work as described. See Control
Other Devices with the Remote later in this chapter.