DoorKing 1802 - Manual (Page 33)

33
3.2.3 Programming Area Codes
Up to 10 different area codes can be programmed for any 10-digit or long distance calling
requirements and will be referenced 0 through 9 (for a total of 10). The area codes will be entered as
a four-digit number (1 + the three digit area code). If area codes are being programmed to facilitate
10-digit calling requirements, precede the three-digit area code with #.
1. Press

and enter the four-digit MASTER CODE
BBBB
(beep).
2. Enter the area code reference number (0 through 9)
B
then press
 EHHS 
3. Enter the area code
BBBB
then press (beep). NOTE-1: for long distance calling
requirements, enter 1 and the three-digit area code. NOTE-2: for 10-digit calling
requirements, enter # and the three-digit area code.
4. Repeat steps 2 and 3 to enter additional area codes. Remember to use a different
area code reference number when entering more area codes.
5. Press  TOGETHER to end this programming step (beeeeeep).
3.2.4 Programming Phone Numbers with Area Code Reference
In this section, phone numbers that are referenced to an area code (long distance and 10-digit dialing
calls) will be programmed. Be sure that the area code(s) have been programmed as described in the
preceding section.
NOTE: If long distance or 10-digit dialing is not required, program the seven digit telephone
numbers as described in 3.2.2.
1. Press

and enter the four-digit MASTER CODE
BBBB
(beep).
2. Enter the directory code (1, 2, 3 or 4 digits depending on what was programmed in
3.2.1) then press
(beep).
3. Enter the area code reference number
B
then press (beep).
4. Enter the seven-digit phone number
BBBBBBB
then press (beep). If the
number that you are entering in this step is less than seven-digits, enter # in the
empty spaces. For example, if the system is connected to a PBX that requires four-
digit extension numbers and you want to enter extension 2217, you would enter this
number as

then press (beep).
5. Repeat steps 2, 3, and 4 to enter additional long distance phone numbers.
6. Press  TOGETHER to end this programming step (beeeeeep).
3.2.5 Deleting Individual Phone Numbers
This programming sequence is used to delete a single phone number under a known directory code.
1. Press

and enter the four-digit MASTER CODE
BBBB
(beep).
2. Enter the directory code (1, 2, 3 or 4 digits depending on what was programmed in
3.2.1) then press
(beep).
3. Press

then press (beep).
4. Repeat steps 2 and 3 to delete additional phone numbers.
5. Press  TOGETHER to end this programming step (beeeeeep).