DoorKing 1802 - Manual (Page 37)

37
3.4.1 Time Clock Programming
This programming sequence programs the calendar chip in the telephone entry system for the current
time and date. The calendar chip must be programmed if you are going to use any of the time
functions available with the entry system.
1. Press
 and enter the four-digit MASTER CODE BBBB (beep).
2. Enter the current hour and minutes BBBB then press (beep). Do not use military
(24 hour) time format, simply enter the hour (2 digits) and the minutes (2 digits). For
example, 8:30 is entered as 0830 whether it is AM or PM.
3. Press 
(beep) for AM, or press 
(beep) for PM.
4. Enter the month BB then press (beep).
5. Enter the day of the month
BB
then press (beep).
6. Enter the year
BB
then press (beep).
7. Enter the day of the week
B
(Sun = 1, Sat = 7) then press (beeeeeep).
3.4.2 Automatic Relay Activation Time Zones
This program sequence sets up time zones to automatically activate and deactivate the relays on the
control board. Each relay can be programmed with two independent time zones. Time zones 1 and 2
affect relay 1 operation; time zones 3 and 4 affect relay 2 operation. Use the chart in the appendix to
record the time zones that are programmed. These time zones can be independently turned on or
turned off after they have been programmed (see operating instructions 5.2.5).
1. Press
 and enter the four-digit MASTER CODE BBBB (beep).
2. Enter the time zone number B then press (beep).
3. Press 
(beep) to turn the time zone ON, or press 
(beep) to turn the time zone
OFF.
4. Enter the beginning hour and minutes BBBB then press (beep).
5. Press 
(beep) for AM, or press 
(beep) for PM.
6. Enter the ending hour and minutes
BBBB
then press (beep).
7. Press 
(beep) for AM, or press 
(beep) for PM.
8. Enter the days of the week
BBBBBBB
then press (beep). To skip any days of
the week, enter # in place of the day. For example, to have a time zone active on
Saturday and Sunday only (Sun = 1, Sat = 7), enter 1 7 # # # # #.
9. Repeat steps 2 through 8 to enter additional time zones.
10. Press

TOGETHER to end this programming step (beeeeeep).
3.4 TIME FUNCTIONS PROGRAMMING