d&b D6 Software - Manual (Page 22)

Options
Back
Device Name
Display
Device Name
Enables the assignment or editing of a device name (maximum 15
characters):
Single characters can be kept by simply pressing the encoder and the
pointer advances by one space after each entry.
Device Name
D6 Xn.n.nn
Ok Cancel
Device Name
Stage righ Stage righ t
jklmnopqrs t uvwxyzäöüß01
Stage right
TUVWXYZÄÖÜ abcdefgh
Device Name
The editing position can be scrolled through the characters by pressing
and turning the encoder simultaneously.
1. Selecting "Device Name" enters the submenu and the cursor is
positioned at the beginning of the "Device Name". As a factory
preset "D6" followed by the firmware version is entered.
2. Pressing the encoder enters edit mode. The pointer, ( ), indicates
the entry position for new or edited characters. A variety of
characters (e.g. capital and lower case letters, numbers 0-9 and
special characters) is displayed in the bottom line.
3. Each character can be highlighted by turning the encoder. Turning
left moves the cursor to the start of the list (A ⇐), turning right to the
end of the list (⇒ @).
4. When you press the encoder, the highlighted letter is entered into
the upper line and the pointer advances by one space.
5. Repeat steps 1 to 4 until the complete device name is entered.
6. Exit edit mode by moving the cursor to the return sign ( ) and
pressing the encoder. An existing entry can be completed using the
return sign at any position. Succeeding letters are deleted
automatically.
Device Name
Stage right
Ok Cancel
Ok
Selecting "Ok" and pressing the encoder confirms the new setting and
exits the submenu "Device name".
Cancel (⇒ ⇒ ⇒ ⇒ Back )
Exits the submenu leaving the previous device name installed.
Display Display
Selecting "Display" and pressing the encoder enters the submenu
"Display Options".
Display Options
Back
Contrast
5
Backlight on
Fig. 12: Display Options
Display Options
Contrast
Enables adjustment of the display contrast.
Backlight
Enables the following settings:
off display illumination permanently off.
On display illumination permanently on.
timeout 10s display is illuminated when the encoder or a MUTE
switch is pressed and switches off 10 seconds after
the last operation.
Note: In "Standby mode" the display illumination reverts to "timeout 10s".
D6 Software manual (Firmware V1.x.x) (1.3 EN) Page 22 of 32