d&b D6 Software - Manual (Page 24)

PS Log PS Log
Selecting "PS Log" ( Power Supply Log) and pressing the encoder
enters the submenu.
Log Power Supply
Back
PS Err
1x
Overvolt. 0x
Temp Off 0x
<40°C
. . .
PS Err
A numerical value indicating the number of times the D6 has entered
the error condition "PS Err".
Overvolt.
A numerical value indicating the number of times the D6 has entered
the error condition "Overvoltage".
Temp Off
A numerical value indicating the number of times the D6 has switched
off with the error condition "Overtemperature" due to overheating.
Temp. (Temperature Log)
Proportionate temperature ranges. They display the proportion of "On
Time" the D6 has been operated within the temperature ranges listed.
Channel A
Channel B
Channel A (B)
Selecting "Channel A (B)" and pressing the encoder enters the submenu.
Log Amp. Channel A
Back
Mute
ISP
. . .
Mute
Proportion of the "On Time" the D6 was muted.
ISP
Proportion of the "On Time" an input signal was present at the D6.
GainRed
Proportion of the "On Time" the D6 has been operated with gain
reduction.
Overload
Proportion of the "On Time" the D6 has been operated with too high
input level or output current.
Amp Prot
A numerical value indicating the number of times the D6 has entered
the error condition "Amp Protect", possibly due to a current overload
caused by a low impedance or short circuit connected to the output.
Amp Err
A numerical value indicating the number of times the D6 has entered
the error condition "Amp Error" due to an internal fault.
Temp Off
A numerical value indicating the number of times the D6 has switched
off with the error condition "Overtemperature" due to overheating.
ImpErrLf
A numerical value indicating the number of times the D6 has entered
the error condition "ImpErrLf" due to a Load Monitoring fault.
ImpErrHf
A numerical value indicating the number of times the D6 has entered
the error condition "ImpErrHf" due to a Load Monitoring fault.
D6 Software manual (Firmware V1.x.x) (1.3 EN) Page 24 of 32