d&b Vi - Manual (Page 17)

2.5.2. Splay/Rear link mechanism
Release the respective Locking pin(s) and fold out the Splay/Rear
link.
2.5.3. Setting splay angles for Vi-TOP cabinets
NOTICE!
The rigging system is designed as an intrinsically safe system. For
this reason, the second Locking pin (Safety pin [S]) must always be
inserted.
The splay angles between adjacent cabinets can be set in the
range from 0° to 14° in 1° steps. The splay angles are set at the
central rear rigging strands of the cabinets.
Vi8/Vi12 cabinets
The Splay link of the Vi-TOP cabinets is designed as a straight link
with two holes.
The inner hole defines the splay angle while the outer elongated
hole is used for the second Locking pin (Safety pin [S]) as shown
in the graphic opposite.
Fig. 15: Splay/Rear link mechanism
Fig. 16: Set splay angle (e.g. 0°)
d&b Vi Rigging manual (1.2 EN) 17