d&b Vi - Manual (Page 4)

1.1. Intended use
The Vi rigging components must only be used in conjunction with
d&b Vi loudspeakers as described in this manual.
1.2. General safety
Installation and setup should only be carried out by qualified and
authorized personnel observing the valid national Rules for the
Prevention of Accidents (RPA).
It is the responsibility of the person installing the assembly to ensure
that the suspension/fixing points are suitable for the intended use.
Always carry out a visual and functional inspection of the items
before use. In case there is any doubt as to the proper functioning
and safety of the items, these must be withdrawn from use
immediately.
Please also refer to Þ Chapter 6. "Care and maintenance /
Disposal" on page 35.
1.3. Load capacity/System safety
Z5387.000 Vi Mounting frame top
The Vi Mounting frame top is designed to suspend smaller arrays
of Vi-TOP or Vi-SUB cabinets with a total system weight of up to
136 kg (300 lb) - SWL, which corresponds to a total weight of up
to 4 x Vi-TOP cabinets.
For any other array configuration which exceeds the maximum
permissible system weight for the Vi Mounting frame top, the
Z5380 V Flying frame must be used.
Note: A detailed description of the Z5380 V Flying frame
including the relevant assembly instructions is given in the V-
Series Rigging manual, which is supplied with the V Flying
frame.
Z5387.001 Vi Mounting frame bottom
The Z5387.001 Vi Mounting frame bottom is designed as a
pullback device to fix and/or pull back an array with either the
Z5387.000 Vi Mounting frame top or the Z5380 V Flying frame
attached at the top of the array.
Alternatively, the frame can be used as an adapter frame to be
mounted underneath SUB cabinets in mixed array configurations
with the Z5380 V Flying frame on top of the array. In this case, the
frame can support a total system weight of up to 136 kg (300 lb) -
SWL, which corresponds to a total weight of up to 4 x Vi-TOP
cabinets.
For any other array configuration which exceeds the maximum
permissible system weight for the Vi Mounting frame bottom, the
Z5380 V Flying frame must be used.
Note: A detailed description of the Z5380 V Flying frame
including the relevant assembly instructions is given in the V-
Series Rigging manual, which is supplied with the V Flying
frame.
1. Safety
d&b Vi Rigging manual (1.2 EN) 4