Doremi S2H-30 - Manual (Page 35)

5.4.7 System Tab
The System tab is illustrated below in Figure 22.
Figure 22: S2H-30 Control Panel System Tab
The parameters are explained earlier in this manual in Section 3.7.
• In addition, the System tab can be used to perform the following functions:
• To save the current settings to flash, click on the “Save Settings” button (see Figure 22).
• To restore the factory default settings, click on the “Restore Default Settings” button (see
Figure 22).
• To enter a new license number, click on the “Enter New License Number ...” button and
type the new license number in the pop-up window (see Figure 22).
• To perform a firmware upgrade, click on the “Firmware upgrade (Current: 1.6.0)” button
– note that this button provides the current firmware version installed on the connected
unit, after “Current: ”. See Section 6.1 for detailed upgrade steps to follow.
• To display the logs, click on the “Display Logs” button.
S2H.OM.001540.DRM Page 35 of 39 Version 1.4
Doremi Labs
Save Settings
Button
Firmware
Upgrade Button
Restore Factory
Defaults Button
Enter New License
Button
Display Logs
Button