Paxton Superchargers Mustang Cobra, NOVI 1000 System - Manual (Page 15)

P/N: 4809640
©2006 Paxton Automotive
All Rights Reserved, Intl. Copr. Secured
03APR06 v1.0 01Cobra(4809640v1.0)
1
3. PREPARING TO INSTALL THE
SUPERCHARGER
A. The air conditioner system fill port (located
near the upper radiator hose) must be bent
from its current, vertical position to a horizon-
tal position parallel to the top of the radiator .
(See Fig. 3-a.) This must be done to clear the
bottom portion of the supercharger .
*** NOTE ***
use extreme caution during this step. The refriger-
ant contained in the line is under high pressure
and can cause injury if the line ruptures. use an
approved tube bender, if available, or use heavy
gloves and bend by hand. In either case, wear
safety goggles/glasses to protect your eyes in case
of a line rupture.
B. Using the supplied bolts, attach the idler sup-
port bracket to the remaining empty holes
from Step 23 . The idler support bracket serves
as a support for the main supercharger bracket
and mounting point for the supplied idler pul-
ley . (See Fig. 3-b.)
Fig. 3-a
Fig. 3-b
Fig. 3-c
C. Remove the 18mm stud bolt that is located
under the lower corner of the passenger side
valve cover . This stud bolt supports the wiring
loom through the use of a small tab . Save the
tab for later step . (See Fig. 3-c.)
Section 3
PREPARING TO INSTAll THE SuPERCHARGER