Paxton Superchargers Mustang Cobra, NOVI 1000 System - Manual (Page 7)

P/N: 4809640
©2006 Paxton Automotive
All Rights Reserved, Intl. Copr. Secured
03APR06 v1.0 01Cobra(4809640v1.0)
1
1. FUEL SYSTEM MODIFICATIONS
Section 1
INSTAllATION
.............. .......*** NOTE ***
Beware of coolant spills . Mop up any spilled coolant
immediately . Radiator coolant is very attractive to
animals,, and highly poisonous .
A. Drain approximately one gallon of coolant
from the radiator and disconnect the negative
side of the battery . Disconnect the MAF sen-
sor, air inlet temp sensor and air idle bypass
hose from the air inlet tube, then remove the
inlet tube and air filter housing by removing
the single 8mm bolt . (See Figs. 1-a, 1-b.)
B. Unplug the throttle position sensor harness,
located on the left side (the side closest to the
firewall) of the throttle body . (See Fig. 1-b .)
Fig. 1-a
Fig. 1-b
Fig. 1-c
Fig. 1-d
C. Unplug the idle air control (IAC motor har-
ness from the IAC, located on the left rear
portion of the upper intake plenum . Unplug
the two vacuum fittings (one on top of the
plenum, one at the EGR valve) to the right of
the IAC . (See Fig. 1-d .)